The process is much easier and simpler. The exact carrier and service used is calculated once the order is packaged for shipment. Be careful as the tab can snap because it is made of plastic, but I pressed it pretty hard and it did not. I am on there quite often and learned most of what I know about the Lexus from that website. You can't see it while you are doing it but it is much easier than taking plastic cover off Bulbs are covered by the factory for Chrysler for 12 months or 12000 miles. Remove the lower strut bolt.
Pry gently to move the assembly forward about an inch or two to completely unlatch the plastic clip that is holding it in place. You have to remove the piece of plastic just inside the trunk where the latch is. It is always best to use cloth your shirt will do in a pinch to handle the bulbs. Headlight restoration will hopefully be solved just by using some headlight polishing products which we have links to Amazon above. You need the H1 kit.
Push battery as far back towards drivers seat in its tray as possible - may have to lift it up and rest it on the tray lip. Take care that the bulb is properly seated in the holder before re-engaging spring clip. Carefully pop out some of the plastic rivets holding the plastic cover. Open up the hood, and go in behind the fixture where the light is located. Then, there is a little metal retaining clip that keeps the bulb in place, and one plug on the end of the bulb.
They should come fairly easy and pop straight out. I was in the same spot as you recently, but now that I've been there, it's pretty simple. I have used the Silverstars on other vehicles and they have variable lifespans, some last less than a year, others more on the same vehicle. Adding More Information If you would like to help the Modified Life community by adding any missing information or adding a new light bulb size information to our resource, please feel free to or post it at the bottom of this page. Remove the 3 upper strut nuts.
Slide that into the notch then replace the black plugs. Remove the clamps and connector. If you don't feel like joining you can always just browse th … e archives and boards, I know I have seen it on there. There should be 2 screws between the bed sides and the tailgate. Don't touch any of them by hand. Find the odometer button and press until it reads the total odometer setting, not the Trip A or Trip B setting. There are 3 bulbs, and they are connected on the same circuit like old-style Christmas lights.
Does anyone know how to repalce the bulbs. The owners manual says to have the Lexus dealer do it!! You have to look down and line up the tabs with the two bottom screws - the ones you didn't remove, just loosen. All you have to do is pull the whole turn signal assembly forward. There is a small box that is separate from the actual headlight housing that is about 2-3 inches wide and about 4-5 inches long. This question is answered with diagrams on page 5-46 of yourowner's manual.
I actually depressed the tab and used a screwdriver to pry the box open from the side and it popped off finally. Orders are shipped from Minnesota, ensuring a reasonable shipping time frame to both coasts as well as the areas in-between. If this 2004 does not qualify then to change the front bulb, remove the 2 screws that hold the lens in and pull the headlight housing out enough to reach behind and twist the bulb out. Takes some pressure because they are snapped into place. The instructions already provided for the '96 are very much on the mark. Have a 3157 bulb handy, it takes about 5 minutes.
Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fixture. Rotate spring clip on its hinge and the bulb is exposed and loose. Powerbulbs also sells Osram among others. Remove screw and carefully slide housing forward. Give this a quarter turn, and remove the bulb holder - I had to move mine back into the engine compartment before lifting it out. We use the United States Post Office and FedEx for our shipments.